ราคาพิเศษ สอบถามโทร 080-6144774 ,02-9810944
CROWN CTs2000 เพาเวอร์แอมป์ เครื่องขยายเสียง Power Amplifier 1000 watt @ 8 ohms
PRODUCT OVERVIEW
Crown’s CTs Series amplifiers provide exceptional performance, flexibility and value for installed sound applications. CTs Series amplifiers feature independent selection of high and low impedance operation for a specific channel, plus power levels and features that were carefully chosen to match the requirements of fixed install design. Easy integration with HiQnet™ and CobraNet™ allows CTs amplifiers to deliver a comprehensive lineup of monitoring and control features along with digital audio transport for an award-winning digital audio solution.
PRODUCT DETAILS
The Crown CTs-2000 is a 2-Channel power amplifier housed in a 2-space rackmount frame, offering power levels and features meant to serve fixed installation sound applications. This amplifier is notable for a completely independent array of switches and indicators for each channel, including high and low impedance operation, input sensitivity, high pass filters, and an advanced level of well designed overload protection circuitry.
- High-power, 2-channel, 2U rackmount amplifier for installed sound applications
- Switching power supply lowers overall amplifier weight
- Direct 70V/100V/140V/200V constant-voltage or 2/4/8 Ohm low-impedance operation
- Independently selectable Input Sensitivity switching per channel
- Rear panel Programmable Input Processor(PIP2) connector accepts accessory expansion modules for specific custom installation requirements
- Thermal Level Control(TLC) circuitry protects amplifier from overheating; engages input compressor, dynamically reducing input gain when individual channels overheat
- Junction Temperature Simulation(JTS) quick-activation circuitry limits drive level of output devices to tolerable range if excess power is required; protects output transistors without shutting down channel
- Continuously variable fan cooling; venting with front-to-rear forced airflow
- Removable balanced terminal block input connectors with "Y" switch
- Switchable high pass filter per channel, eliminates step down transformer saturation in distributed systems
- Complete array of front panel function and warning indicator LED's for each channel
- Complete array of rear panel function and filter switches
- Power on indicator flashes when AC mains are under or over voltage
- Advanced protection circuitry covers shorted outputs, DC, mismatched loads, overheating, high frequency overloads, voltage fluctuation and internal faults.
-
SPECS
Power Rating
1000 Watts @ 8 Ohms, Dual (Per Channel)
Damping Factor
10 Hz - 100 Hz:>3000
Input Sensitivity
Switchable:
1.4V(8/4 Ohms)
26 dB Gain:
2.46V(4 Ohm Load)
3.47V (8 Ohm Load)
1.4V(70V)
Input Impedance
10 kOhms balanced(nominal), 5 kOhms unbalanced(nominal)
Gain
63.9:1 (36 dB)
Frequency Response
20 Hz - 20 kHz +/-0.25 dB @ 1 Watt
Signal-to-Noise Ratio
105 dB A-Weighted, below rated power(20 Hz - 20 kHz)
Total Harmonic Distortion (THD)
< 0.35%, at full rated power (20 Hz - 20 kHz)
Input Connections
2 x Balanced 3-Pin Terminal Block Connectors(one per channel)
Output Connectors
1 x 4-Pole Terminal Strip(Ch 1, Ch 2)
Controls Front Panel
1 x Power Switch
Controls (Rear)
1 x Reset Switch
1 x Rotary Channel Level Control(per channel)
1 x 2-Position Operation Mode Switch
1 x Highpass Filter Switch(per channel)
1 x "Y" Input Switch
1 x Interior 3-Position Input Sensitivity Switch(per channel)
Indicators
Front Panel:
1 x Yellow LED Bridge Mode Indicator
1 x Green LED Ready Indicator
3 x Green LED Signal Indicators(per channel)
1 x Red LED Clip Indicator(per channel)
1 x Red LED Thermal Indicator(per channel)
1 x Red LED Fault Indicator
1 x Yellow LED Data Indicator(per channel)
1 x Blue LED Power Indicator
Back Panel: No Indicators on Back Panel
Cooling
Continuously Variable Speed Fans
Ventilation Grille(Front),Cooling Vents(Back)
Front-to-Rear forced airflow
Power Consumption
35 Watts (120 VAC Mains)
Dimensions
19 x 3.5 x 14.25" (483 x 89 x 362mm)
Weight
27.0 lb (12.2 kg)
Specialties
Variable Speed Fan Cooling
Thermal Level Control
JTS Limiting Circuitry